--------------------------------------------------------------------------------

Command: run Delft3D-WAVE
   Starting Delft3D-WAVE computation ...
--------------------------------------------------------------------------------
-  Delft3D
-  Deltares, Delft3D-WAVE Version 3.07.00.62434, Oct 24 2018, 14:38:32
-  Open source
-
--------------------------------------------------------------------------------
*** MESSAGE: Delft3D-WAVE runs stand alone
 Done reading input
  Initialising grids and grid mappings
  Start loop over SWAN grids, time =           0.000
  Allocate input fields
  Allocate and read SWAN depth
  Write SWAN depth file
  Deallocate input fields
  Write SWAN input
<<Run SWAN...
>>...Check file swan_bat.log

C:\Daten\Delft3D\spi\spi_002\runs_loc\r010>rem exit 
>>...End of SWAN run
  Allocate output fields
  Read SWAN output
  WARNING: Found negative value(s) for dissip(2) in swanout file;
           value(s) set to zero
  Write WAVE map file, nest          1 time           0.000
  Time written          0
  Write WAVE NetCDF map file, nest          1 time      0.000
Delft3D-WAVE finished normally.